NGS Technology DOMO Mode D'emploi page 3

USER'S MANUAL
gETTIng STARTED
Setting up a Wireless Infrastructure Network
For a typical wireless setup at home (as shown below), please do the following:
Wireless Repeater Mode
You will need WiFi
AP/Router Internet access
Wireless AP Mode
You will need broadband
Router Internet access
Connect the Domo Repeater to your
Router/Switch with RJ-45 cable.
All manuals and user guides at all-guides.com
HOW TO cOnfIgURE THE DOMO REPEATER
You can configure the Domo Repeater after connecting it with your computer/
laptop with enclosed RJ45 cable or wirelessly.
A. configure the Domo Repeater wirelessly
A1. Plug the Domo Repeater to a wall socket.
A2. Click on the network icon
Router
A3. Open web browser and type
note: Please check whether the Domo Repeater accord with factory default
settings once you can't open http://192.168.10.1. If you are still not sure what
reasons, you can reset the Domo Repeater, just need to press the reset button
for 10 seconds, then try again.
Router
3
or
right bottom of your desktop. You will find
the signal from the Domo Repeater. Click
on "Connect" and wait for a few seconds.
http://192.168.10.1 in the browser's
address box. This number is the default IP
address for this device.
on the