Publicité
Les langues disponibles
Les langues disponibles
Electrical Installation
The model stated on the front cover is rated at 120V AC,
60 Hz and uses a NEMA 5-15 plug to connect to a
dedicated 120 V microwave circuit.
Electrical Requirements:
a three prong grounded outlet
120 V, 60 Hz, AC only
15 Amp electrical supply with a fuse or a circuit
breaker
Install Appliance
Note: The appliance is heavy. It is advisable to install it
with a second person.
NOTICE: Before installing the appliance, be sure to
verify the cabinet dimensions and electrical connections.
Mount to Cabinet
Fully insert the appliance and center it. Do not kink the
1.
electrical cable.
Screw the appliance into place.
2.
Testing Operation
Turn on power at the breaker.
1.
Test the microwave:
2.
Place a cup of water into the oven cavity. Follow the
instructions in the Use and Care Manual on how to
heat a beverage.
NOTICE: Never run the microwave unless there is
food in the oven cavity.
8
This product must be connected to a supply circuit of the
proper voltage and frequency. Wire size must conform to
the requirements of the National Electric Code or the
prevailing local code for this rating. The power supply
cord and plug should be brought to a separate 20-amp
branch circuit single grounded outlet. The outlet box
should be located in the area behind the appl iance (see
section Cabinet Dimensions ). The outlet box and supply
circuit should be installed by a qualified electrician and
conform to the National Electrical Code or the prevailing
local code.
The voltage used must be the same as specified on the
data plate of this microwave oven. Using a higher voltage
is dangerous and may result in a fire or oven damage.
Using a lower voltage will cause slow cooking. The
manufacturer is not responsible for any damages
resulting from the use of the oven with any voltage other
than specified.
Verify that the oven light comes on and the water is
3.
heated.
If any of the tests do not result as explained above,
4.
contact Service for assistance. Otherwise, the
installation is complete at this time.
Publicité
