PRCAST-C001 Installation Guide
This caster wheel installation guide is only applicable for the following models: PRB24C01AS-OD,
PRKB24C01AG, PRKB24C01AS-OD, and PRR24C01AS-OD.
In order to install the caster wheels onto the kegerator models, PRKB24C01AG and PRKB24C01AS-OD,
both PRCAST-C001 and its spacers, 56240027, are required.
To convert the stationary unit into a moble unit, please follow the instructions below. Installing the
caster wheel accessory should require at least two people to prevent injury.
1. Empty all contents within the cooler and close the door afterwards. Lay the cooler gently down on
its right side.
2. Remove the leveling legs from the cooler by twisting the leveling legs counterclockwise. Perform
this step for each leveling leg.
3. Place and align the spacers over the screw hole openings underneath the kegerator, making sure
the larger opening of the spacer is over the compressor bolt.
NOTE: Only install the spacers if the compressor bolt interferes with the caster installation. If a spacer
is used, make sure to use one for each caster; otherwise, the cooler will unevenly stand.
4. Install each caster wheel by aligning it with the spacer and securing it with (4) M5*12 screws and
washers. Perform this step for each corner.
5. Set the cooler back to its upright position. Place all contents back into the cooler.
3
2
1
4
2
This step is only for PRKB24C01AG
and PRKB24C01AS-OD.
5
Caster Wheel Installation Guide
P R E S R V ™
C A S T E R W H E E L
3