LevelOne FNS-1020 Guide D'installation Rapide page 4

All manuals and user guides at all-guides.com
Installation
1. Unfasten the two screws
from the rear and remove
the back panel.
3. Make sure the jumper on
your hard drive is set to
Master
* Consult the instructions on your
hard drive as it differs from each
manufacturer.
2. Pull out front panel and
inner tray.
4. Install your 3.5-inch IDE or
SATA hard drive and connect
the data and power cables.
Then use the screws provided
to fasten the hard drive.
4