mitzi H124601 Instructions D'assemblage Et De Montage

ASSEMBLY AND MOUNTING INSTRUCTIONS
GENERAL
WARNING-DISCONNECT POWER BEFORE RELAMPING OR
•
WIRING THE FIXTURE. TURN OFF THE ENTIRE ELECTRICAL
CIRCUIT TO WHICH THE LIGHTING FIXTURE IS ATTACHED
INSTALLATION AND MAINTENANCE OF THIS FIXTURE
•
SHOULD BE COMPLETED BY A LICESNSED ELECTRICAN
FAILURE TO INSTALL FIXTURE CORRECTLY COULD RESULT
•
IN SERIOUS INJURY OR DEATH
READ ALL INSTRUCTIONS BEFORE STARTING INSTALLATION.
•
INSTALLATION
STEP 1.
Pull the wires out from the outlet box, and install
mounting plate onto the outlet box using the (2)
mounting screws. Strip the fixture wires ½" long at the
ends.
STEP 2. Fasten bare ground wire to ground wire from the wall
outlet box (usually green or copper color) or connect
ground wire to green screw on the mounting plate.
STEP 3.
Connect the neutral (white) fixture wire coming from the
fixture base to neutral (usually white) outlet wire. Fasten
both wires together with a plastic wire nut and tightly
wrap the wire nut with electrical tape.
STEP 4. Repeat the previous step with the hot (black wires). Make
sure there are no exposed wires or strands that could
DIMMING
The fixture can be controlled by a wall dimming device. Only use
triac/electronic dimmer. Make sure carton is marked for use with LED
compact fluorescent-incandescent light source only. These can be
CLEANING
Please clean with a soft, dry cloth ONLY! Do not use cleaning products.
www.hudsonvalleylighting.com/mitzi
H124601 CLARA SEMI FLUSH MOUNT
IF AN EXISTING FIXTURE IS BEING REPLACED, REMOVE IT AND
•
NOTE TO WHICH WIRE IN THE OUTLET BOX THE ORIGINAL
FIXTURE WAS ATTACHED.
BEFORE DISCARDING THE CARTON DOUBLE CHECK THE
•
PACKAGING TO MAKE SURE ALL PARTS HAVE BEEN FOUND.
THIS FIXTURE WAS DESIGNED TO BE MOUNTED TO AN
•
OCTAGON OUTLET BOX. THE BOX MUST BE SECURELY
MOUNTED TO THE STRUCTURE OF THE BUILDING.
cause a dangerous short circuit.
FAILURE TO CONNECT THE APPROPRIATE WIRES
CORRECTLY COULD RESULT IN SEROIUS INJURY OR
DEATH!
STEP 5. Carefully place connections back into the outlet box
STEP 6. Lift Canopy up over the mounting plate and secure with
mounting nuts.
STEP 7. Install the lamp(s). The fixture is rated for 60 watt T lamp.
DO NOT EXCEED RECOMMENDED WATTAGE!
STEP 8. Lift glass shade up and screw onto glass fitter.
STEP 9. Restore power to the circuit at breaker or fusebox
provided by your local electrical distributor, home center, or
hardware store.
| #mymitzi