Pleasant Hearth LS938-144 Mode D'emploi page 3

ASSEMBLY INSTRUCTIONS
1. Attach two horizontal base bars (B) to the vertical end (A)
by inserting 4 carriage bolts (AA) through the predrilled holes
in the vertical end (A), the predrilled holes in the spreader bar
(C), and the predrilled holes in the horizontal base bars (B).
Insert two washers (CC) between the vertical end (A) and the
spreader bar (C) on the bottom hole only. Then, insert two
washers (CC) between the spreader bar (C) and the horizontal
base bars (B) on the bottom hole only. Then secure all bolts
with nuts (BB). Tighten with the wrench (DD).
Repeat with the second vertical end (A), two additional
horizontal base bars (B), and the second spreader bar (C).
Hardware Used
M8x90mm Carriage
AA
Bolt
BB
Nut
Washer
CC
Wrench
DD
2. Attach the remaining horizontal base bars (B) to the
completed end assemblies by inserting 8 carriage bolts (AA)
through the predrilled holes in the horizontal base bars (B)
and the remaining two spreader bars (C). Insert two washers
(CC) between the completed assemblies on the bottom holes
only, then secure all bolts with nuts (BB). Tighten with the wrench
(DD).
Hardware Used
M8x90mm Carriage
AA
Bolt
BB Nut
Washer
CC
Wrench
DD
CARE AND MAINTENANCE
• Keep the log rack protected from elements.
• Do not attempt to overload the rack.
1
x 4
x 4
x 4
2
x 8
x 8
x 8
3
C
B
CC
BB
C
B
C
AA
CC
BB
A
AA