HURAKAN HKN-MD1 Mode D'emploi page 14

EN
4. Operating instruction.
4.1 Turn on the power.
4.2 The oven temperature can be set from 0 to 300°C.
4.3 Turn the knob of the timer to set the required time, the heating indicator turns on and the
oven starts working. When the set temperature is reached, the heating indicator will turn
off. If the temperature falls below the set temperature, the oven will automatically start
heating and the indicator will light up again.
4.4 Internal lighting allows you to monitor the cooking process.
4.5 Cooking time depends on the number of products. The more products you put, the longer
time it takes.
4.6 Turn off the power if the oven is not in use.
5. Safety precautions
5.1 When you need cleaning, repairing or moving the furnace, first of all, disconnect the unit
from the power supply.
5.2 Do not touch the plug or socket with wet hands.
5.3 It is forbidden to wash the machine under running water. Avoid the switch getting wet.
5.4 Do not allow children to touch or use the device.
5.5 The oven should be grounded. Check all connections after maintenance.
6. Service and maintenance.
6.1 Before starting maintenance, disconnect the oven from the power supply. When the oven
has cooled down, you may start cleaning it.
6.2 For daily care, use a dry cloth. It is forbidden to wash the oven under running water. To
clean the stone, remove it from the oven, clean the surface with a soft brush, rinse with
water and dry. Do not use any agents to clean the stone, as they can be absorbed and
subsequently affect the taste characteristics of the prepared food.
6.3 We advise you to check the furnace with a certified electrician once a month.
7. Troubleshooting
Trouble
No heating
Short circuit
Internal lighting does not
work
An unpleasant smell of
burning
Uneven baking
8. Technical specifications
Model
Temperature range, ℃
Exterior dimensions, mm
Chamber dimensions, mm
14
All manuals and user guides at all-guides.com
Possible solution
1. Check the connections
2. Turn the thermostat knob and set the desired temperature.
3. Make sure the switch meets the required parameters.
4. Contact your service center.
Contact your service center
Turn off the power and let the oven cool down. Install a new
lamp.
Contact your service center
Adjust the thermostats for each heating element, make sure
they are workable. If the thermostats work properly, contact a
service center to diagnose the heating elements, they may need
to be replaced.
HKN-MD1
0~300
560х485х265
415х400х120
HKN-MD11
0~300
560х485х430
415х400х120х2pcs