Publicité
Les langues disponibles
Les langues disponibles
MASTER SWITCH
The master switch controls the power supply to the appliance. Turn the switch to "I" to connect power
and turn the switch to "O" to cut the power. There will be a chiming sound when turning to "I".
POWER ON/OFF
Touch the button once (icon will light up) to turn power on for all functions. Touch the button once more
to turn all functions off.
FLAME INTENSITY
Touch the button once to increase the flame intensity. There are 5 levels in total. The display will show
L1, L2, L3, L4, L5 to indicate the current intensity.
HEAT SETTINGS
This fireplace consists of a fan forced electric heater with two heat settings: 700W ("LO" shown in
display) and 1350 W ("HI" shown in display). Touch the button once (the icon will light up) to activate
the heater at its low level (700W). Touch the button once more to active the heater at its high level
(1350W). When set in high level, touch the button once again to deactivate the heater.
Note: The fan will continue to run for a short time and turns off automatically after the heater is turned
off.
TIMER
This fireplace is equipped with a timer ranging from 1hr to 9hrs, in 1-hour increments (1H, 2H....9H is
shown in display). Touch the button once for every 1hr increment.
Do not leave heater unattended.
DISPLAY
By default, the current room temperature (Celsius) will be shown.
REMOTE CONTROL FEATURES
-Install the CR025 3V battery (included) in the remote control before use.
The master switch must be turned to "I" to operate the remote control.
All functions are the same as on the control panel, as listed on previous page.
- 8 -
Publicité
