Publicité
Les langues disponibles
Les langues disponibles
English
Included material:
1. 1x U46B
2. 3x D912 M6x65
3. 1x 7113.08000
Note:
All fixing screws shall be tightened to the
torques specified in the table below.
Standard quality:
8.8
Recommended torque for screws and bolts
Tightening torque [Nm]
Diameter
Class 5.8
M2
0.22
M3
0.77
M4
1.8
M5
3.6
M6
6.1
M8
15
Fixing the tool holder on the machine
1. Assemble the motor, mounting plate and
drive wheel (1) on the connecting plate (3)
with the screws (2).
2. Attach the connecting plate (3) to the tool
holder base body (6) with the screws (4).
3. Position the tool holder on the machine with
the pin and align with a dial indicator, then
tighten the screws (5).
4. Connect the motor and the motor cooling.
5. Mount the protective plates (7).
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Operating instructions
Tool holder
Screw M6x65
Lug wrench ER8
Class 8.8
Class 10.9
Class 12.9
0.35
0.49
0.58
1.2
1.7
2.1
2.9
4
4.9
5.7
8.1
9.7
9.8
14
17
24
33
40
PCM Precision Tooling SA
Copyright © PCM Precision Tooling
Mode d'emploi
Betriebsanleitung
U46B
Use
1. Settle the offsets of 2 positions.
2. During the assembly or the dismantling of
your tools of cup, to block the brooch on
dishes planned for that purpose.
3. The diameter of tail of a tool of cup never has
to have a difference furthermore of 0.4mm
regarding the diameter of the crowbar.
Example: Ø of crowbar 9.5mm - Ø tail 9.1
minimum.
NOTE:
-
Never use the chuck with empty
positions. Use the supplied plugs.
-
The Back gang tool post must be up for
the front gang tool post to machine or the
horn QDF3101 can collide with U46B !
e.g: U46B can't be used while drilling on
the back spindle.
SWISS MADE
SA.
Document :
Garant:
U46B Mode
BT
d'emploi.docx
Validation :
Page : 2 de 3
02.03.2023
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email: sales@pcm.ch
Publicité
