Télécharger Imprimer la page

Zeck Audio STAC VISION 1.4 Consignes D'utilisation page 5

Les langues disponibles

Achtung! Vor Öffnen des

Gerätes Netzstecker ziehen.

Caution! Do not remove cover

before disconnecting mains plug

Power

Mains

Slave

Remote Control

Footswitch

Connect the unit to the mains supply with the supplied mains cord. The included footswitch

is connected to the 'Remote Control Footswitch' jack on the rear of the unit with the sup-

plied 8 m cable. After turning the STAC

heatup. After this period, the STAC

The lit green LED on the footswitch indicates that the unit is now in 'standby' mode. A fog

output can now be generated as long as the footswitch is depressed for a maximum contin-

uous duration of 20 seconds. After this time, the unit needs a short period of reheating

which is indicated by a dark LED. After the green LED is lit again, the unit is again in 'stand-

by' mode and a new fog output can be generated.

More S T A C f og generators can be connected to the unit for simultaneous trig-

gering by making use of the 'Slave' output. The 'Slave' output of the first STAC

is simply connected to the 'Remote Control Footswitch' jack of the subsequent unit with a

3-pole jack (stereo) cable. This way, a virtually unlimited chain of STAC fog generators can

be hooked up which are simultaneously triggered by the first unit via its footswitch.

Have a lot of fun and success with your STAC

See for technical specifications on page 25

All manuals and user guides at all-guides.com

owner`s manual

Vision 1.4 on, give the unit 6 minutes for an initial

Vision 1.4 is ready for operation.

Vision 1.4