Husqvarna PP 480 HF Manuel D'utilisation page 14

DRIVE CHOICES
SET GEAR (WS 482 HF)
WS 482 HF is fitted with two mechanical gears. State which
gear is set. Choose from between the following options:
• 1. (600-900 rpm)
• 2. (800-1200 rpm)
SET DRIVE MODE
Set the required drive mode depending on if the power unit
will be used for wall sawing or wire cutting. Choose from
between the following options:
• BLADE (wall sawing)
• WIRE (wire cutting)
NOTE! Performance cannot be guaranteed if the drive choice
and the application do not match.
SET ROT. DIR.
The direction of rotation can only be altered when the blade/
wire is not moving.
Select the required direction of rotation. Choose from
between the following options:
• STANDARD
• REVERSE
SET FUSE
State which fuse the power unit is connected to. Choose from
between the following options:
• 16A
• 25A
• 32A
To be able to use full power output, the power unit must be
connected to a 32 A fuse. With a 16 A or 25 A fuse the power
output is lower so as not to overload the fuse.
SET WATER VALVE
Used to control the water valve in the power unit.
• "ON" - The water valve is always open.
• "AUTO" - The water valve opens when the rotation control
is turned up from its zero setting. Otherwise the water
valve is closed.
The water flow is adjusted with the ball valve at the incoming
water connector on the power pack.
MENU SYSTEM
SETTINGS
RUN TIME
STOP WATCH
On activation, a stop-watch is started to count the time the
blade/wire rotates and at least one feed is active.
RESET STOP-WATCH
Used to reset the stop-watch.
TIME & DATE
SET TIME
State the current time.
SET DATE
State the current date.
TIME FORMAT
Select the required time format. Choose from between the
following options:
• 12 h
• 24 h
DATE FORMAT
Select the required date format. Choose from between the
following options:
• YYYY-MM-DD
• YYYY/DD/MM
• DD/MM/YYYY
SET LANGUAGE
Select the required display language.
SET UNITS
Select the required units. Choose from between the following
options:
• AMERICAN
• METRIC
PAIR RADIO
Pair remote control with machine.
RADIO CHANNEL
The remote control must be connected to machine with a
CAN cable.
Select the required radio channel. Choose from between the
following options:
• 0 (2.410 GHz)
• 1 (2.415 GHz)
• ...
• 11 (2.465 GHz)
– 13
English