Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Repeater Installation and Operation Instructions
NOTE
This Repeater must be matched to the main wall control of the HRV / ERV. This process is
called "Pairing". Multiple Repeaters can be paired to a single wall control, however a second
Repeater cannot be used to increase the range of the first Repeater.
The RX02 Repeaters are to be plugged directly into a 120V power outlet.
Pairing:
Turn on the main wall control by pressing the
1.
ON/OFF button
2. RX02 with DX Series Controls:
and right buttons simultaneously on the main wall
control (
and RESET buttons). The screen will
go blank and the wireless symbol
flashing on the bottom right of the display. This
indicates that the main control is now in pairing
mode. (Figure B)
3. RX02 with BC Series Controls:
and right buttons simultaneously on the main wall
control (
and either
on the main control). The bottom row of 3 LED's
will begin flashing. This indicates that the main
control is now in pairing mode. (Figure C)
4. Keep the Repeater within 16" of the main wall
control when pairing. If an outlet is not nearby
available, an extension cord should be used to
power the Repeater next to the main wall control.
5. Plug the RX02 Repeater into the power outlet.
After approximately 12 seconds the green LED will
flash, then go solid indicating that the Repeater is
paired with the main wall control. A solid red light
indicates pairing was not successful.
6. Press the
button on the main wall control to
exit pairing mode when Repeaters have been successfully paired.
To pair additional RX02 Repeaters with the same wall control, or if pairing was not successful,
repeat steps 1-6.
When paired, the RX02 Repeaters can be moved and plugged in elsewhere.
All manuals and user guides at all-guides.com
.
Press the left
will appear
Press the left
or
buttons, depending
Figure A
RX02 Repeater
120V Power
Plug
Figure C
BC Series
Control
NOTE:
Your BC
control may look
different than the
one shown.
Press Simultaneously to
Initiate Pairing Mode
DX Series
Control
Press Simultaneously
to Initiate Pairing
Mode
Figure B
TI-RX02
10_19_15
Publicité
Sommaire des Matières pour Airia DX Serie
- Page 1 Repeater Installation and Operation Instructions All manuals and user guides at all-guides.com NOTE This Repeater must be matched to the main wall control of the HRV / ERV. This process is called "Pairing". Multiple Repeaters can be paired to a single wall control, however a second Repeater cannot be used to increase the range of the first Repeater.
- Page 2 All manuals and user guides at all-guides.com Répéteur RX02 – Installation et fonctionnement ATETNTION Ce répéteur doit être apparié à la commande murale principale du VRC / VRE. Ce processus s'appelle le "pairag". On peut apparier plus d’un répéteur à une commande murale unique, mais un second répéteur ne peut pas servir à...
- Page 3 All manuals and user guides at all-guides.com Caution: Changes or modifications not expressly approved Airia Brands Inc. could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.