Sinbo SVC 3470 Mode D'emploi page 3

All manuals and user guides at all-guides.com
PRECAUTIONARY MEASURES
If the opening that sucks in the air, the suction pipe or the telescopic wand stick on pipe are blocked,
you should switch off the vacuum cleaner at once. First clear the blocked substance before you attempt
to start the vacuum cleaner again.
1. Do not operate the vacuum cleaner too close to heaters and like
cigarette butts etc.
2. Before you insert the plug into the wall contact make sure your
dry.
3. Before you start using the vacuum cleaner, please remove large
or sharp objects from the floor in order to prevent that the paper
damaged.
4. When you want to pull the plug from the wall contact, please
the plug itself and not by means of the electrical cable.
This vacuum cleaner is equipped with a plug and a cable, which rolls up automatically.
If anything gets damaged, both the plug and the cable must been repaired by a qualified repairman or
electrician.
ASSEMBLING VACUUM CLEANER
Always remove the plug from the power socket before fitting or removing accessories!
1. Fitting or removing the flexible hose
Fitting:
Insert flexible hose into the air intake duct on the top of appliance.
Press until it clicks into position.
Removing:
Removing the plug from the power socket. To release the flexible
hose firmly from the air intake duct.
2. Fitting the extension tubes and accessories
a. Fitting the extension tube to the handle.
b. Fitting the extension tubes.
Extension Tube
Floor Brush
c. Fitting the brush to the extension tube.
d. Fitting Floor brush
Ideal for the daily cleaning on carpets and hard floors.
- 10 -