Publicité
Les langues disponibles
Les langues disponibles
4.
TECHNICAL CHARACTERISTICS
5. FAQs
PROBLEM
The device
does not heat
The device is in energy-saving mode
up
Incorrect setting of the set temperature
The room
Improper sizing
does not reach
the desired
Excessive height
temperature
Input and output grids are obstructed
Set temperature below room temperature
The radiator
Control panel switch and protection down
does not
operate
Switch is off
Program is OFF
Radiator located at a very low height
The radiator
stains the
Dust accumulation in the lower grid.
walls
Type of painting on the wall
Blocked
No response from operating buttons
buttons
Description:
Measures:
Weight:
Description:
Measures:
Weight:
Description:
Measures:
Weight:
Description:
Measures:
Weight:
Description:
Measures:
Weight:
Description:
Measures:
Weight:
TECHNICAL CHARACTERISTICS
Voltage:
Frequency:
Plug:
Safety Thermostat:
Electronic Thermostat:
Type of Protection:
Back Frame
Front STEEL
Front CLASSIC
PROBABLE CAUSE
MEASURES & WEIGHT
STEEL 800 W
450 x 450 x 50 (mm)
5.5 Kg.
STEEL 1500 W - 2000 W
900 x 450 x 50 (mm)
10.20 Kg.
STEEL 800 W VERTICAL
450 x 900 x 50 (mm)
10.20 Kg.
CLASSIC 800 W
500 x 1000 x 70 (mm)
10.35 Kg.
CLASSIC 1500 W - 2000 W
1000 x 500 x 70 (mm)
20,20 Kg.
CLASSIC 800 W VERTICAL
500 x 1000 x 70 (mm)
20,20 Kg.
203 V
50 Hz
Bipolar 10-15 A/250 VAC
Automatic – Cut-off Tª 90 ± 0,5º - Reset Tª 65º ± 10º
Temperature Oscillation from 17-24ºC
Class II IP 24
MATERIALS
High-quality Steel
White Satin Steel RAL 9001
DUAL KHERR
Due to the thermal inertia, the device transfers heat to the room; should you need
more temperature, increase the device temperature.
Check the set temperature on the display to verify it is the desired temperature.
The power is not the adequate for the place in which it has been installed.
Make sure the system is installed at the recommended height
Do not place anything on top of the radiator and do not install it inside a hole made in
the septum.
Rise the radiator's set temperature until it is 1 degree above the room temperature
Check that the automatic control is not down. If it is down put it up.
Make sure the installation is correct and that there are independent lines for the
heating system with a 2.5 mm2 cable gauge and a maximum power of 3500 w.
Set the switch in position I.
Check that the set program is the chosen one or set the one you desire.
The minimum height from the floor to the radiator's lower part must be at least 25
cm.
Vacuum it. The vacuuming should be done at the beginning of each heating season.
Paints with a high content in rutile are likely to darken.
Press buttons ON and TIMER for 3 seconds.
SOLUTION
Publicité
