Unitec MAB 150 Mode D'emploi page 11

C o m p o n e n t s / d e l i v e r y
c o n t e n t s
M a c h i n e o v e r v i e w
1 Core drill
(not supplied as standard)
2 Tool mount
3/4" Weldon (19 mm)
3 Gearbox
4 Connecting nipple
for cutting oil/drilling emulsion
(covered)
5 Handle
6 Hand lever (can be attached on both
sides)
7 Drive engine
8 Operating panel (covered)
9 Magnetic foot
10 Magnet ON/OFF switch
11 Motor switch
Green = motor on
12
Red = motor off
D e l i v e r y c o n t e n t s
MAB 150 magnetic core drilling
machine
Transport case (not illustrated)
A ZAK075 ejector pin
B Safety chain
C ZKP 100 pump bottle
for cutting oil/drilling emulsion
SW 4 offset screwdriver
(not illustrated)
O p t i o n a l a c c e s s o r i e s
Y Attachable ratchet
(can be attached on both sides)
Z ZHS 400 high-performance grease
spray
M A B 1 5 0
All manuals and user guides at all-guides.com
As standard, the machine is supplied with
the components indicated in the Delivery
contents section.
This section contains important instructions
on the required preparation before
beginning any work.
Additional safety precautions must be
taken for the following operations with the
machine:
No n - h o r i z o n t a l w o r k p o s i t i o n
Before using for the first time
T r a n s p o r t i n s p e c t i o n
NOTE
► Check for visible signs of damage or
missing items on delivery. Report an
incomplete or damaged delivery to
your supplier/retailer immediately.
P r e p a r a t i o n
A d d i t i o n a l s a f e t y m e a s u r e s f o r
c e r t a i n w o r k
W A R NING
R i s k o f i n j u r y f r o m a f a l l i n g m a c h i n e .
When working in inclined or vertical
position and during overhead work, the
machine must be secured to prevent it
from falling using the safety chain (B)
supplied.
► Check the safety chain for proper
function before every use. A damaged
safety chain must not be used.
Replace a damaged safety chain
immediately.
P r e p a r a t i o n
1 3