Publicité
Les langues disponibles
Les langues disponibles
Keep the special key in position and use the supplied
torque screwdriver to fasten the three Torx screws
passing through the holes [8].
Fastening torque = 2Nm
ATTENTION : always make sure that these three
torx screws are well fastened before using the
tool holder!
8
Calculate the angle for the net you want to produce.
−1
�� = ������
With
�� = ℎ�������� ���������� ���� ��������������
�� = ���������� ��������ℎ ���� ����
��
= ���������� ���������������� ���� ����
1
��
= ���������������� ���������������� ���� ����
2
Swirl calculator available at:
http://tools.pcm.ch/fr/thread-whirling-calculator/.
Loose the 4 M4 screws (5), then adjust the inclination
of the tool holder and tighten the 4 M4 screws (5).
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
0400-SW016-RA0000-1S03
2 ∙ ��
�� ∙ ( ��
)
+ ��
1
2
PCM Precision Tooling SA
SWISS MADE
Copyright © PCM Precision Tooling SA.
Garant:
BT
Validation: 19.07.2023
To make an accurate adjustment of the whirler, use a
feeler on the reference side of the reglangle supplied in a
bag, which must first be attached to the housing [9].
(See reglangle instructions for use)
Check the angle with the probe by moving the axis.
The measuring instrument should read ZERO.
Once the adjustment has been made, dismantle the
angle for production.
Correct the machining positions according to the
desired angle.
Note
: the use of some whirling head with a big
inclination angle can cause a potential collision
with the guide bushing in Y1 axis !
In this case, use M151 (CITIZEN) code in the
program to move in X1 axis and skirt the collision area
when a new tool is called.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
Document:
0400-SW016-
RA0000-1S03 mode
d'emploi.docx
Page: 4 de 4
9
∆��
sin �� =
∆��
sales@pcm.ch
Publicité
