Sommaire des Matières pour DeFehr FURNITURE Jasper
Page 1
All manuals and user guides at all-guides.com BED ASSEMBLY ASSEMBLAGE DU LIT IMPORTANT! Two people are required for safe Depending on model purchased, unit may not assembly of the unit. be exactly as shown. IMPORTANT! Deux personnes sont nécessaires Selon le modèle que vous avez acheté, le meuble pour assembler ce meuble en toute sécurité.
Page 2
All manuals and user guides at all-guides.com TOOLS REQUIRED / OUTILS NÉCESSAIRES The use of a power screwdriver is #10220 optional where indicated. L'utilisation d'un tournevis électrique est facultative là où elle est indiquée. Hex Key 4mm (included) Clé Hexagonale 4mm (inclus) HARDWARE / QUINCAILLERIE #19922 #19923...
Page 3
All manuals and user guides at all-guides.com STEP 1 1-1/8” Page 3 of 12 • Comp #P2096 • Revision #0 • 07/2019...
Page 4
All manuals and user guides at all-guides.com STEP 2 Optional/ En option 1” Page 4 of 12 • Comp #P2096 • Revision #0 • 07/2019...
Page 5
All manuals and user guides at all-guides.com STEP 3 Optional/ En option 1-1/4” For a proper fit, the support should be centred between the brackets on the footboard. There will be a very small overlap on either side. Pour un bon ajustement, le support doit être centré entre les supports du pied de lit.
Page 6
All manuals and user guides at all-guides.com STEP 4 45mm Page 6 of 12 • Comp #P2096 • Revision #0 • 07/2019...
Page 7
All manuals and user guides at all-guides.com STEP 5 Headboard, footboard, and bed rails. Connect Brackets at all 4 (four) corners as shown. Tête de lit, pied de lit et rails de lit. Fixer les supports aux 4 (quatre) coins, tel qu’illustré. Page 7 of 12 •...
Page 8
All manuals and user guides at all-guides.com STEP 6 The brackets may need to be tapped into place to be fully seated. If necessary, slightly loosen the screws in the headboard or footboard brackets to allow for an easier fit. MAKE SURE TO RETIGHTEN THE SCREWS once the brackets are seated.
Page 9
All manuals and user guides at all-guides.com STEP 7 Optional/ En option 1-1/4” Page 9 of 12 • Comp #P2096 • Revision #0 • 07/2019...
Page 10
All manuals and user guides at all-guides.com STEP 8 Secure all four corner brackets with one screw. 5/8” Fixez les quatre supports en corniére avec une vis. Optional/ En option STEP 9 1-1/2” Optional/ En option Page 10 of 12 • Comp #P2096 • Revision #0 • 07/2019...
Page 11
All manuals and user guides at all-guides.com STEP 10 Place one slat at each end of the supports and Optional/ space the remaining two evenly between them. En option Placez une latte à chaque extrémité des 1-1/2” supports et espacez les deux autres de manière égale.
Page 12
All manuals and user guides at all-guides.com STEP 11 Queen bed shown / Lit Queen montré. X4 Queen X5 King Lift bed into place. DO NOT PUSH BED ONCE FULLY ASSEMBLED. Soulever le lit en place. NE PAS POUSSER LE LIT UNE FOIS ASSEMBLÉ. Page 12 of 12 •...