Safety/Warning - Loewe bild v.65 Mode D'emploi

 Loewe bild v | Operating manual 2

Safety/Warning

Safety/Warning
For your safety, and to avoid unnecessary dama-
ge to your unit, please read and follow the safety
instructions below.
Key
This symbol indicates risks caused by
high voltages.
This symbol is to alert the user to other,
more specific risks.
This symbol indicates dangers caused
by the development of fire.
This symbol indicates dangers caused
by sharp edges.
Do not remove set rear panel
Warning: When opening or removing the rear
panel, there is the danger of electric shock and
the risk of serious injury from high voltages.
ATTENTION
ELECTRIC SHOCK DANGER
– DO NOT OPEN
Never open the rear panel yourself. Leave repairs
and servicing work on your TV set to qualified,
authorised television technicians.
Please contact your dealer or our customer
service.
Intended use and environmental conditions
This TV set is intended exclusively for the
reception and playback of picture and
sound signals.
The TV set is designed for dry rooms
(living rooms and office spaces). It must
not be used in rooms with a high level
of humidity (e.g. bathroom, sauna) or
outdoors.
When using the set, make sure that it is
protected from moisture (dripping and
splashing water or condensation).
High humidity and dust concentrations
lead to power leaks in the set. This can
lead to danger of injury and damage to
the set by electric tensions or a fire.
If you've brought the set from the cold
into a warm environment, leave it off for
around an hour due to the formation of
condensation.
Do not place objects filled with liquid over
the set. Protect the set from dripping and
splashing water.
Candles and other
open flames must
be kept away from
the set at all times to
prevent the fire from
spreading.
The materials we used in this device
comply with all regulatory requirements.
However, the migration of substan-
ces cannot be ruled out. We therefore
suggest you avoid permanent contact
between food and the TV set.
Transport
Improper handling during transportation
can lead to damage to the display and
risks of injury.
The screen consists of glass or plastic
and can break if handled improperly.
At least two people are required to trans-
port the set. Only transport the set in a
vertical position.
No pressure should be applied to the
glass or the plastic during transport.
The correct unpacking of the set is
shown in the operating manual 1.
To avoid damaging the mechanical
structure of the TV set and the floor
stand, remove the TV set from its base
and move the two parts separately.
When the TV set is set up in its new
location, at least 2 people are required
to reassemble it.
Mains cable/power supply
Unplug the power cord immediately from
the mains socket if you notice something
unusual, or the unit shows recurring mal-
functions.
Incorrect voltages can damage the set.
This set may only be connected to a mains
power supply with the voltage and fre-
quency indicated on the rating plate using
the enclosed mains cable.
The mains power plug of the TV set must
be easily accessible so that the set can be
disconnected from the mains at any time.
When pulling the mains power plug out,
do not pull the cable but the plug housing.
The cables in the mains power plug could
be damaged and cause a short circuit
when plugged in again.
A mains power cable with a damaged in-
sulation can lead to electric shock and
presents a fire hazard. Never use a dama-
ged mains cable.
Lay the mains cables so that they cannot
be damaged. Do not tread on the mains
cable.
The mains cable must not be kinked or
laid over sharp edges.
If you use a portable multiple socket to
connect the TV set, do not cascade seve-
ral multiple sockets consecutively.
Air circulation and high temperatures
Like any electronic device, your TV set
requires air for cooling. If air circulation is
impeded, it may result in a fire.
The ventilation slots on the rear panel of
the set must therefore remain free. Plea-
se do not cover the set.
Wall mounting:
Leave at least 10
cm of space all
around the set at
the side, above
and below.
Table / stand
foot: Leave at
least 10 cm clear
space around
the set at the
side and at the
top.
Foreign bodies
Foreign bodies inside of the set can lead
to short circuits and fires.
Danger of injury and damage exists.
Therefore avoid metal parts, needles,
paper clips, liquids, wax or similar pas-
sing through the ventilation slits of the
rear panel into the interior of the set.
Should something get into the interior of
the appliance, immediately pull out the
mains power plug of the set and inform
the customer service department for
checking.
Installation
Opting for an incorrect or wrongly moun-
ted installation can lead to accidents.
Rolling or falling sets can cause injuries
or damage.
Loewe TV sets are specified for Loewe
accessories. We strongly recommend
the use of original Loewe installation op-
tions. Do not use any installation options
that are not approved for your TV set!
Note the instructions regarding the
mounting for the different possible
installation options! A corresponding
documentation is included with every
Loewe product.
Check before the installation of the set,
whether the final location with regard to
the surface (pressure sensitivity) and
stability (static) is designed for the load
from the set! This applies in particular
to high-gloss lacquered surfaces and
surfaces made of real wood, real wood
veneer and plastic surfaces.
Only place the TV set on a level, stable,
horizontal base with table or stand foot!
The set should especially not protrude
at the front when installing it in or on
furniture.
Do not place the television set on cloth
or other materials that may be located
between television set and supporting
furniture. Educate children about dan-
gers of climbing on furniture to reach the
television set or its controls.
11