Cassia X2000 Guide De Démarrage Rapide page 7

All manuals and user guides at all-guides.com
5) Connect Ethernet cable and PoE
Remove the ETH/PoE plug (M22X1.5. Please don't mix with the USB hole plug),
pass the Ethernet cable through the cable gland, insert the RJ-45 connector into
the Ethernet port of X2000, and tighten the cable gland in the order of a, b, c. The
torque of step c should be less than the torque of step a.
NOTE: When removing the cable gland, please follow the order of c, b, a. Otherwise
X2000 will be damaged.
ETH/PoE
a
NOTE: In order to remove the Ethernet cable once it's been installed, please use the
supplied screwdriver in the X2000 box or a small pointed tool of your choosing to
depress the plastic release tab on the cable. See image below.
a c
b
ETH/PoE
b
ETH/PoE
6
ETH/PoE
c