Beko ATP 5100 I Manuel D'instructions page 11

To Operate Your Air Purifier
7
1. Connect the appliance with power source,
one "Bi" can be heard.
2. Touch the Power button once, "Bi-Bi" can
be heard, the appliance starts to run under
under the default "Medium" setting, and its
corresponding indicator will illuminate. Touch
the "Power button" again if you want to turn
off the appliance.
Hold and Touch the "Pow-
NOTE:
er button" for 2 seconds if you
C
want to enter into the sleep
mode. To recover, hold and Touch
the "Power button" for 2 seconds
again.
3. And you can select your required speed set-
ting by following the operation described in
"CONTROLS INTRODUCTION". After select,
the corresponding indicator of selected speed
setting will turn on.
4. After turn on the air purifier and select your
required speed setting, you can activate the
timer by following the operation as below:
Touch down Timer button on the control
panel, one beep "Bi" can be heard. There are
3 settings including 2H, 4H and 8H for selec-
tion. After select your required timing, the
indicator of selected timing will illuminate.
When the timer expires, the air purifier will
power off automatically and the indicator of
selected timing will extinguish.
Air purifier/ Instruction Manual
Air purifier/ Instruction Manual
All manuals and user guides at all-guides.com
The appliance is of mem-
NOTE:
ory function. When being turned
C
on again, the appliance will work
according to the speed setting
saved last time.
5. When the filter change indicator illumi-
nates in white, it is time to change the HEPA
filter. Please change the HEPA filter by follow-
ing the operation described in the section of
"CHANGE THE HEPA FILTER".
11 / EN
11 / 108 EN