Lightning Audio Strike S4.525C Installation Et Fonctionnement page 3

INSTALLATION REFERENCE SHEET
Surface Mounting
• Drill hole to route wires for tweeter.
• Mount housing using sheet-metal screw.
• Snap Tweeter into mount after wires have been connected.
4. Route the wires from Crossover and through the hole for speaker
and/or Tweeter.
5. Attach the wires and be sure to observe the proper speaker
polarity.
6. Place the speaker frame behind the speaker.
7. Place the speaker into the hole and screw the speaker into place.
8. Snap the speaker grille over the speaker onto the speaker frame
Crossover Settings
Tweeter Control
Depending upon the acoustics of the vehicle, the placement of the
speakers, and the listening preferences of the listener, it may be
desirable to adjust the output of the tweeter in relation to the
midbass. There are three (3) different settings for the tweeter.
The default shipped setting is 0dB, meaning the tweeter output is
equal to that of the midbass, and settings of -6dB and –3dB that
allow for different levels of tweeter control.
To Attenuate Tweeter
1. Remove Plexiglas cover from the top of the crossover.
2. Move the jumper from the 0dB position and place the jumper across two (2)
jumper posts at the desired attenuation level. Make sure when moving the
jumper to cover both posts.
3. Replace the Plexiglas cover on the top of the crossover.
Speaker
Grille
Speaker
Screw
Speaker
Frame
All manuals and user guides at all-guides.com
Tweeter
Flush
Mount
Input from
Source Unit
or Amp
Crossover
Tweeter
Tweeter
Surface
Mount
3