Greenheck SP-6 Manuel D'instructions page 3

INSTALL THE HOUSING
(continued)
Existing Construction
4. Place housing in opening so that its bottom edge is flush
with finished ceiling. Nail to joist through keyhole on both sides.
To ensure a noise-free installation, drive another nail through
the top hole of each mounting bracket.
5. Additional mounting holes are provided for installations where
access from above is inconvenient or not possible. Nail or screw
housing directly to joists or framing.
INSTALL THE DUCTWORK
1. Snap the damper/duct connector onto housing. Make sure that
tabs on the connector lock into slots in housing. Top of damper/
duct connector should be flush with top of housing.
2. Connect 4" round duct to damper/duct connector and extend
duct to outside through a roof or wall cap. Check damper to
make sure that it opens freely. Tape all duct connections to make
them secure and air tight.
All manuals and user guides at all-guides.com
ADDITIONAL
MOUNTING
HOLES
FLUSH
CONNECT THE WIRING
SCHEMATIC WIRING DIAGRAM
B L K
O N / O F F
S W I T C H
B L K
W H T
L I N E W H T
I N
G R D G R D
S W I T C H B O X
ON / OFF SWITCH
(purchase separately)
SWITCH BOX
120 VAC
LINE IN
1. Wire unit following diagram above. Run electrical cable as direct
as possible to unit. Do not allow cable to touch sides or top of
unit after installation is complete.
ATTACH THE GRILLE
OPTIONAL TABS
SLOT IN
MOTOR PLATE
GRILLE
SPRING
2. Push grille up
against ceiling.
MODEL SP-6
Page 3
B L K
W H T
M
U N I T
BLACK
WHITE
RECEPTACLE
GROUND
(bare)
WIRING
PLATE
1. Squeeze grille springs
together and insert
springs into slots in mo-
SPRING
tor plate.
TABS
NOTE: If desired, rotate
o
grille 90 and move
springs to optional tabs.