Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
I
MAINTENANCE
House-
hold
Drain
Cleaner
No
Thinner
Filter handle
Electrostatic Filter
WARNING
It is necessary to stop the air conditioner and disconnect the power
supply before cleaning.
Cleaning the indoor unit and remote controller
CAUTION
• Use a dry cloth to wipe the indoor unit and remote controller.
• A cloth dampened with cold water may be used on the indoor unit if
it is very dirty.
• The front panel of the indoor unit can be removed and cleaned with
water. Then wipe it with a dry cloth.
• Do not use a chemically treated cloth or duster to clean the unit.
• Do not use benzine, thinner, polishing powder, or similar solvents for
cleaning. These may cause the plastic surface to crack or deform.
Cleaning the air filter
A clogged air filter reduces the cooling efficiency of this unit. Clean the filter once
every 2 weeks.
1.
Lift the indoor unit panel up to an angle until it stops with a clicking sound.
2.
Take hold of the handle of the air filter and lift it up slightly to take it out
from the filter holder, then pull it downwards.
3.
Remove the AIR FILTER from the indoor unit.
• Clean the AIR FILTER once every two weeks.
• Clean the AIR FILTER with a vacuum cleaner or water.
• Ensure before replacing that the filter is completely dry and has no defects.
4.
Remove the Electrostatic Plasma Filter only when applicable from its support
frame as shown in the Figure on the left.
CAUTION!
Do not touch this Electrostatic Plasma Filter within 10 minutes after
opening the inlet grille, it may cause an electric shock.
5.
Clean the Electrostatic Plasma Filter with water, and, if necessary with a mild
detergent. Ensure before replacing that the filter is completely dry and has
no defects.
6.
Install the air freshening filter back into position.
7.
Insert the upper portion of air filter back into the unit taking care that the
left and right edges line up correctly and place filter into position.
4
115
Publicité
Chapitres
Table des Matières
