MTP-Racing MTP5686ANB Instructions De Montage page 2

Assembly Instructions
MTP5686ANB Adapter plug for controller
FH020AAoder SH847
EN
The three cables coming from the stator are
connected to the grey adapter plug. The black adapter
plug is used to connect the cables that lead to the
battery.
1. Cut the cables from the original regulator.
2. Remove a piece of the cable insulation and thread
the rubber sleeves on the single cables.
Then you can crimp the metal plugs onto the cables
using a crimping pliers. Please note that the positive
cables and ground cables must be brought together
in each case!
Stator
MTP-Racing GmbH
Zornedinger Straße 19 • DE-85614 Kirchseeon OT Buch
mtp-racing.de • info@mtp-racing.de • Tel.: +49 8091 5628500
3. Insert the cables into the adapter plugs. The black
plug connects the positive wires on the inside and
the ground wires on the outside. The grey plug
occupies all three connections. Push the rubber
bands upwards for sealing.
4. Insert the yellow terminal strip from above and
connect the adapter plug to the new controller.
2