Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Problem Tip
Cannot use Bluetooth:
• Make sure 3.5mm connector is not
plugged into AUDIO IN jack on rear panel.
• Make sure your phone, tablet or other
media device supports Bluetooth.
• Make sure to connect to the IKEA device
called FREKVENS 10x20.
• Make sure your phone, tablet or other
media device is paired and that its Bluetooth
is turned on.
•Make sure no other Bluetooth devices
in the room are paired. If so, turn off the
Bluetooth function in that device.
Poor sound quality when playing
via Bluetooth:
• If Bluetooth reception is poor, move the
device closer to the speaker or remove
any obstacles between the device and the
speaker.
Note: Bluetooth reception will normally
operate at a distance of up to 6-8m in
conditions with an unobstructed path. When
objects, furniture or walls are in between,
Bluetooth reception will be reduced. When
the device is placed in pockets of clothes
or in a bag, Bluetooth reception can be
reduced.
Poor sound quality when playing
via AUDIO IN input:
• Make sure your phone, table or other
media device is not at maximum volume, if
so, turn down the volume.
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by
IKEA is under license. Other trademarks and
trade names are those of their respective
owners.
This equipment complies with radio
frequency exposure limits set forth by the
FCC for an uncontrolled environment.
This equipment should be installed and
operated with a minimum distance of 20
cm between the device and the user or
bystanders.
This device must not be co-located or
operating in conjunction with any other
antenna or transmitter.
This device complies with Part 15 of the
FCC Rules/Innovation Science and Economic
Development Canada's licence-exempt RSS
standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation of the device.
WARNING:
Any changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user's
authority to operate the equipment.
NOTE:
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the quipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
— Reorient or relocate the receiving
antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced
radio/TV technician for help.
6
Publicité
