Télécharger Imprimer la page

La Boite Concept LP160 Notice page 48

Publicité

Les langues disponibles

Les langues disponibles

5.
5.1
CLEAN UP YOUR LP/AP 160
Before cleaning the device, disconnect it from the power socket. Clean the
device only with a dry cloth. Do not use cleaning alcohol or solvent to clean
the device's surface. It could damage the lacquer and cause electrical failures
and fire if it went into the electronic devices. Don't try to clean inside your LP/
AP 160, except the drawer.
5.2
NO POWER
Make sure the power cable is correctly connected. Make sure that the plug is
fully inserted in the power socket and that it is powered on.
Check that the switch (15) located below the speaker and near
the arrival of the power cable is switched on. Check the fuse state in the power
plug (14) or the universal adapter.
Make sure the device is switched on and that the white LED (7) on the control
panel (ref. p.43 section 4.4) is ON.
5.3
NO SOUND
Make sure that the volume is tuned to an audible level and that the LED indica-
tors (7) and (8 ) are turned off. Make sure the connection of your source on the
source panel is correct and that you have selected the corresponding source
(1) to (6) on the control panel. The corresponding LED must be on.
Finally, if you still have no sound, increase the volume by pressing the VOL +
button (9).
5.4
DISTORTED SOUNDS AND NOISES
Check the connections of your music players. Make sure that all the connecting
cables are correctly fastened, especially the earth/protection shield connec-
tions. Make sure that your cables are in good conditionning.
48
All manuals and user guides at all-guides.com
HOW TO ?

Publicité

loading

Ce manuel est également adapté pour:

Ap160