Télécharger Imprimer la page

IKEA FIXA Serie Mode D'emploi page 10

Publicité

Les langues disponibles

Les langues disponibles

a quarter turn counter clockwise to lock it
into place.
Connect the hose of a vacuum cleaner to
the dust extraction adapter (9).
To remove the dust extraction adapter (9),
twist the dust extraction adapter a quarter
turn clockwise. Pull the dust extraction
adapter from the machine.
The vacuum cleaner must be suitable
for the ma terial being worked. When
vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a
special vacuum cleaner.
OPERATING MODES
Before any work on the machine itself,
pull the mains plug.
WARNING! To reduce the risk of
injury, never use the tool when the base
plate (4) is loose or removed.
Adjusting the Cutting Angle
(see figure B).
The base plate (4) can be swivelled by
45° to the left or right for mitre cuts.
Insert a saw blade (6).
Loosen the two socket head screws
(14) and lightly slide the base plate (4)
toward the vacuum connection (8). For
adjustment of precise mitre angles, the
base plate has adjustment notches on
the left and right at 0°, 15, 30 and 45°.
Swivel the base plate (4) to the desired
position according to the scale (3).
Afterwards, push the base plate (4)
to the stop in the direction of the saw
blade (6). Other mitre angles can be
adjusted using a protractor but then the
adjustment notches do not work.
All manuals and user guides at all-guides.com
Position the holder for the guide roller
(7) in such a manner that the guide
roller (5) faces against the back of the
saw blade. Precise cuts are possible only
when the guide roller faces closely but
not to tightly against the back of the saw
blade.
Tighten the two socket head screws (14)
again.
Starting Operation
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine.
Switching On and Off
To start the machine, press the On/Off
switch (1).
To lock the On/Off switch (1), keep it
depressed and push the lock-on button (2).
To switch off the machine, release the On/
Off switch (1). When the On/Off switch (1)
is locked, press it first and then release it.
HINTS FOR OPTIMUM USE
General
When working small or thin work pieces,
always use a sturdy support.
Sawing laminates
As the saw blade cuts on the upward
stroke, splintering may occur on the
surface closest to the base plate.
Use a fine-tooth saw blade.
Saw from the back surface of the
workpiece.
To minimise splintering, clamp a piece of
scrap wood or hardboard to both sides
of the workpiece and saw through this
sandwich.
Sawing metal
Be aware that sawing metal takes much
more time than sawing wood.
9

Publicité

loading