Publicité
Les langues disponibles
Les langues disponibles
Kit Contents
1 GV60 outdoor receiver with conformal coating—
to resist weather—part no. 4005111
1 Overlay conversion label—part no. 4006081
1 Outdoor Lighting Instructions card—part no. 4005169
Replace the existing receiver
Locate the existing receiver on the appliance. The
receiver is held in place by Velcro on most appliances.
Refer to the appliance's manual if necessary.
1. Detach the receiver and pull it out of the appliance
to disconnect it. Be careful not to pull too hard
as you could damage the wire connections,
particularly the ignition wire connection.
2. Remove all the wires connected to the receiver and
set the receiver aside.
3. Connect the outdoor receiver (G6R-R3AMC) to the
existing wiring. DO NOT INSTALL BATTERIES
YET! Ensure no batteries are installed in the
RBWSK if used. Connections on the outdoor
receiver are identical to the existing receiver. See
diagram below.
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER OR RBWSK until the
wires are connected to the burner control unit as
short-circuit could result in the destruction of the
electrical components.
Take the switch wire and plug it into the receiver's
connection slot as indicated.
IMPORTANT: The
connection can only be
done one way. Do not
force it or damage the
pins on the receiver
box!
CAUTION
To avoid short-circuit to the receiver,
position the antenna so that it DOES
NOT TOUCH the ignition wire.
2
All manuals and user guides at all-guides.com
4. Install and connect the wall switch supplied with
5. Insert 4 AA alkaline batteries into the outdoor
6. Test the operation of the wall switch—see
Wall Switch
Harness
Valve Wire
Harness
Ignition Wire Connection
(spade type connector)
Be careful when removing and
reinstallaing: not to bend or
break the spade connector
G6R-R3AMC—
Outdoor receiver
the appliance to the receiver following instructions
provided with the appliance's installation manual;
if the appliance is not supplied with a wall switch,
connect the RBWSK—Remote battery and wall
switch kit (supplied separately) to the outdoor
receiver—see installation instructions supplied with
the kit.
receiver or the RBWSK kit only after all connections
are completed.
appliance's or wall switch kit instructions manual.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the receiver or
the handset! This could cause a short circuit to the
receiver.
Red
Yellow
Conversion label and
Lighting Instructions
RBWSK—
Remote Battery
Wall Switch kit
power connector
Ignition
Wire
Antenna
Publicité
