Corsair XENEON 32QHD240 Mode D'emploi page 5

ASSEMBLY (FOR CM-9020002 ONLY)
Before you begin, you will need a Phillips head screwdriver.
1. Remove the top layer of foam that includes accessories and stand to expose the rear of the panel.
2. Carefully open the foam bag covering the panel (see image 1) to expose the mounting area. Do not remove
the panel from the bag.
3. Align the monitor post with the mounting slots on the back of the panel (see image 2). Slide the upper hooks
into the mounting slots on the rear of the panel. Using a Phillips screwdriver, secure the post to the panel with
the 4 screws (see image 3).
4. Attach the stand base to the monitor post (see image 3) and tighten the captive thumbscrew into the bottom
of the post (see image 4).
5. Slowly remove the monitor from the packaging and sit upright on your desk. Do not touch the front of the panel
while lifting the monitor.
1
3
ENGLISH
2
4
4