Publicité
F E AT U R E S - O P E R AT I O N S
ASSEMBLY INSTRUCTIONS
Assembly Time: 10-15 minutes.
Tools Required: Phillips head screw driver.
NOTE: MAKE SURE YOU REMOVE ALL CONTENTS FROM
THE PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR
PARTS THAT COULD BE REQUIRED TO OPERATE YOUR FAN.
Base/Pole Assembly
You will need the base cover (R), weight (S), outer pole
(P), washer (T) and T-shaped locking lever (U).
1. Turn the base cover upside down and place the
weight into the base cover.
2. Insert the threaded end of the T-shaped locking lever
into the hole of the washer, weight and through the
base cover.
Fig. 1
A
B
V
A Front Grill
B. Fan Blade
C. Securing Screw
D. Grill Mounting Nut
E. Rear Grill
F. Motor Shaft
G. Plastic Sleeve
H. Motor Housing
I. Speed Control Knob
J. Oscillation Control Knob
K. Tilt Adjustment Knob
L. Fan Head Locking Knob
M. Fan Head's Neck
N. Inner Pole Extension
O. Pole Locking Knob
P. Outer Pole
Q. Additional Short Pole
R. Base Cover
S. Weight
All manuals and user guides at all-guides.com
E
G H
C D
F
L
Q
R
S
T
T. Washer
U. T-Shaped Locking
Lever
V. Grill Screw and Nut
3. While holding the base cover and weight with one
hand vertically, connect the outer pole to the base,
sliding the T-shaped locking lever into the bottom of
the outer pole with your other hand.
4. Turn the T-shaped locking lever clockwise to securely
attach the pole to the base.
5. Set the base on the floor, weight side down.
Fan Head Assembly
You are now ready to assemble the fan head.
1. Remove the protective sleeve (G) and unscrew grill
mounting nut (D) by turning counter-clockwise from
the motor shaft (F). Position the rear grill (E) over
the motor shaft (F), making certain that the vertical
slots at the top and bottom of the rear grill fit over
the prongs on the motor housing (H). Make sure that
the carry handle is topmost on the motor assembly.
2. Secure the rear grill (E) in its place using the rear
grill mounting nut (D). Turn this nut clockwise and
I
tighten firmly.
J
3. Loosen the securing screw (C) on side of the fan
blade (B) to slide the fan blade onto the motor shaft
(F) through the rear protrusion. Make sure the
K
securing screw (C) rest on the notch (flat side) of
motor shaft and tighten the screw (C).
M
CAUTION: Avoid contact with sharp end of blades.
N
4. Centre the front grill (A) by aligning the Bionaire
logo on the logo plate so that it is horizontal and
O
parallel with the floor. Then place the bracket at the
top over the front and rear grills with the hole on the
bracket going through the center vertical bar. Fasten
P
the other clips, making sure they go over both the
front and rear grills.
5. Replace grill screw and nut (V) and tighten with screw
driver.
Final Assembly
NOTE: The fan head locking knob (L) is attached with
the additional short pole (Q) when shipped.
U
1. Slide the inner pole extension (N) up from the outer
pole (P), first loosening the pole locking knob (O), to
securely hold this position. Tighten the pole locking
knob (O).
2. Place the fan head assembly into this extension pole,
inserting the fan's head neck (M) into the pole
opening.
®
Publicité
