Sunny Health & Fitness RC2301 Manuel D'utilisation page 3

REMOTE CONTROL FUNCTIONS:
Note: If the treadmill does not respond to the remote control, you will need to resync the
treadmill and remote control. To sync the remote control with the treadmill, press the
start/pause button on the remote control for five seconds, and you will hear a "beep" sound
that means the remote control have resynced with the treadmill.
1. START/PAUSE BUTTON: Press the START button, so that treadmill begins running. 0.8 KM/H
(KM per hour) is the default start speed. During exercise, you also can press this button to pause
the machine.
2. SPEED +/– BUTTONS: Press the +/- buttons to increase or decrease the speed in increments of
0.1 KM/H (KM per hour). Pressing and holding either of these buttons for a duration of over ½ a
second will increase or decrease the speed continually.
3. STOP BUTTON: When in use, press the STOP button to terminate your workout session
completely. All data will be deleted and reset to the initial setting.
4. DISPLAY SWITCH BUTTON: When in use, you can press this button to switch the display
between Time, Distance, Calories, Steps and Speed value.
5. BATTERY POWER INDICATOR LIGHT: When you press any button on the remote, the light will
blink three times if the battery is low. Please proceed to change the battery. If it does not blink,
then the battery is not low.
*NOTE: The maximum speed on this treadmill is 6.0 KM/H (KM per hour).
PROGRAMS
TIME (MIN: SECOND)
SPEED(KM/H)
DISTANCE(KM)
STEP
CALORIE(KCAL)
Initial Default Value
0:00 -
0.0 0.8
0.00 -
0 -
0 -
Set Range Display Range
- 0:00—99:59
0.8-6.0
- 0.00--99.99
-
-
0.8-6.0
0-99999
0.0--9999