Publicité
Les langues disponibles
Les langues disponibles
MOUNTING POSITION
DESKTOP USE:
Connect the telephone line cord to the TEL LINE jack
on the rear of the base unit and connect the opposite
end to the telephone modular jack.
WALL USE:
A. WITH A STANDARD MODULAR WALL JACK
1.
Install the wall mount bracket at the position as shown in Figure 4.
2.
Connect the short telephone line cord to the TEL LINE jack on rear of the base unit.
3.
Connect the opposite end of the telephone line cord to the modular wall jack.
4.
Align the wall mounting slots with the studs located on the modular wall plate and slide
the base down to lock in place.
Base Unit
(Side View)
NOTE: If you do not have a standard modular wall jack, find a qualified technician to mount
one on the wall.
B. WALL MOUNTING (No Standard Wall Jack)
1.
Drill two holes with a vertical distance between the two
marked positions of 3
2.
Drive a screw into each of the holes. Tighten them to the
end of the screw line, only leaving the smooth part of the
screw head outside the wall.
3.
Hang the unit onto the screws, then slide it down firmly to
fasten the base securely.
BASE RETAINER TAB
If the base unit is to be placed in the wall mount position, the base retainer tab allows the
handset to hang onto the base unit.
Retainer Tab
All manuals and user guides at all-guides.com
Telephone Modular
Wall Jack
Wall Mount
Slots
Wall Mounting
Bracket
(Figure 4)
" (100 mm) as shown in Figure 5.
15/16
(Figure 6)
10
(Figure 3)
Studs
3
"
15/16
(100 mm)
(Figure 5)
Publicité
