Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

HARDWARE
BOOKCASES
A S S E M B L Y I N S T R U C T I O N S
(1) Top rail
8 camlocks
8 camstuds
21 dowels
shelf pins
screws for
(pre installed)
(4 per shelf)
back panel
May include spare hardware
Note: the camlocks are tightened by turning them clockwise
Tools required: a phillips screwdriver, a hammer and/or a rubber mallet.
1
Use the phillips screwdriver to screw 8 camstuds (4 per side)
into the underside of the sides, as shown.
side
Join the bottom rail to the bottom panel and the top rail
3
to the top panel.
NOTE:when attaching the bottom rail and top rail the
pre drilled holes on the unfinished (back) section of these 2
parts must face the BACK OF THE SHELF.
top rail
top panel
bottom panel
PIECES
(2) Side panel
(1) Top panel
(1) Bottom rail
(1) Bottom panel
2
Insert 4 camlocks into the top panel and 4 camlocks into
the bottom panel, with arrows facing out, as shown detail.
bottom panel
top panel
Connect the assembled parts to the side panels.
4
Use the phillips screwdriver to rotate the camlocks
clock-wise to tight them.
bottom rail
5
Attaching the back panel
(1) Back panel
The back panel can be attached two ways :
screws can be hammered into the holes, or with a sloted
screwdriver.
If one side of the back panel is unfinished, put the unfinished
side facing the outside.
back panel
30"h = (1) Shelf
36"h = (2) Shelves
48"h = (3) Shelves
60"h = (4) Shelves
72"h = (5) Shelves
84"h = (6) Shelves
screw
detail
arrow
hole
Insert the shelf pins at the desired levels for what you
6
wish to store.
When shelves are placed on the shelf pins, make sure
the finished front edge of the shelf is facing to the front
of the Bookcase.
shelves
pin

Publicité

loading

Sommaire des Matières pour Lorell 60074

  • Page 1 PIECES HARDWARE BOOKCASES Insert the shelf pins at the desired levels for what you Attaching the back panel (1) Back panel The back panel can be attached two ways : wish to store. A S S E M B L Y I N S T R U C T I O N S When shelves are placed on the shelf pins, make sure screws can be hammered into the holes, or with a sloted screwdriver.
  • Page 2 PIEC»S VISSERIE BIBLIOTH»QUES Fixation du panneau arriËre: InsÈrez les goupilles de tablettes ‡ la hauteur dÈsirÈe selon (1) Panneau arriËre ce que vous avez l'intention de placer. Le panneau arriËre peut Ítre fixÈ de deux facons: INSTRUCTIONS D'ASSEMBLAGE Lorsque les tablettes sont dÈposÈes sur les goupilles de Les vis peuvent Ítre martelÈes dans les trous, ou Ítre tablettes, assurez-vous que l'extrÈmitÈ...
  • Page 3 PIEZAS FERRETERIA LIBREROS Inserte las clavijas para repisas a los niveles desados, Una el panel posterior. (1) Panel posterior El panel posterior se puede unir de dos maneras: dependiendo de lo que desÈe colocar en las repisas en INSTRUCCIONES DE ENSAMBLE las repisas.