Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Attach the motor assembly to the angle adjusting joint of the clip by the butterfly head screw and nut.
OPERATING INSTRUCTIONS
1. Fan speed is controlled by the toggle switch (LO [Low] – OFF – HI [High]). The airflow can be
adjusted upward or downward by loosening the angle adjusting joint. Retighten knob securely.
2. The direction of air flow can be adjusted by turning the rotary joint.
3. Plug the power cord into a wall outlet.
MOUNTING INSTRUCTIONS
1. Place the clip onto a secure structure. The clip can accommodate a ¾" to 1-
Figure 1, below).
2. Figures 2-4 illustrate the wrong way to clip to a structure and the wrong kind of structures to clip
onto. Clip as shown in Figure 1 to reduce the risk of damage.
YES
Fig. 1
CLEANING
1. Be sure to unplug from the electrical supply source before cleaning.
2. Plastic parts should be cleaned with mild soap and damp cloth or sponge. Thoroughly remove
soap film with clean water.
3. Be sure not to allow water or other liquids to enter inside of motor.
USER SERVICING INSTRUCTIONS
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug
by pulling on cord.
2. Push on tabs located next to the blades to open fuse cover.
3. Remove fuse carefully.
4. To avoid risk of fire, replace fuse only with 2.5 Amp, 125 Volt fuse.
5. Close fuse cover and push cover closed so that all tabs latch.
IMPORTANT SAFETY INSTRUCTIONS
Please read all instructions before using the product.
1. To reduce the risk of fire or electrical hazard, do not use this fan with any solid state
speed control device.
2. This fan has a polarized plug (one blade is wider than the other). To reduce the risk of electric
shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in
www.Hydrofarm.com
2
INSTRUCTIONS
NO
¾" – 1-¹ /
"
8
Fig. 2
Fig. 3
/8" thick structure (see
¹
Fig. 4
Publicité
