linarie HUEZ LK90TTBG Manuel D'utilisation page 4

THIS APPLIANCE MUST BE PROPERLY EARTHED. It is
most important that this basic safety requirement is
present and tested regularly and, where there is any
doubt, the household wiring system should be inspected
Due to the special characteristics of the tempered glass,
the tempered glass may be exploded at the probability
rate of 3‰- 5‰ according to the industrial estimate,
while this company will strictly control it within 3‰.
2.3 Correct use and Operation
For safety reasons, this appliance may only be used after
it has been built in.
Reliable and safe operation of this appliance can only be
assured if it has been connected to the mains electricity
supply.
Before using the appliance, ensure that all packaging
materials are removed from the appliance and make
sure that the connection data on the data plate [voltage
(V) and frequency (Hz)] indicated on the appliance
corresponds to the voltage and frequency of the power
supply in your household. Consult a qualified electrician
if in doubt.
D O NOT store or spray flammable materials in the
appliance or near this appliance while it is in operation
(e.g. aerosols).
Cracks, fissures or fractures in the glass ceramic panels
can damage the underlying electronics. Switch off and
disconnect the appliance immediately.
2.4 Disassembling and Disposal of the
Appliance
(see the "Environmental Tips" section for best practices on
disposing of this appliance).
The device must only be disassembled by trained
specialists who are familiar with and comply with the
standard national regulations and supplementary
regulations of the local utility companies.
Work on electrical components must only be conducted by
trained electrical personnel.
www.linarie.com.au
by a qualified electrician.
Linärie cannot be held liable for noncompliance with
these instructions, resulting from incorrect or improper
use or operation.
Regarding the information pertaining to the installation,
handing, maintenance, servicing and disposal of the
appliance, thanks to refer to the paragraph
"TRANSPORT AND HANDING" "INSTALLATION"
"CLEANING AND CARE" "TROUBLESHOOTING"
of the manual.
Prevent water ingress. Never sprinkle or flush the cooler
using water, nor place the cooler in an area exposed to
moisture or water sprinkling, let alone filling the cooler
with water, so as to avoid impairment of the electric
insulativity of the cooler. Furthermore, failing to follow
such requirements may lead to electric shock and fire,
or other accidents.
After the cooler is put into operation, never touch its inner
icing surface, especially when your hand is wet; otherwise
the skin may stick onto the inner surface to get injured.
Opening the door for long periods can cause a significant
increase of the temperature in the compartments of the
appliance.
Clean regularly surfaces that can come in contact with
food and accessible drainage systems. If the refrigerating
appliance is left empty for long periods, switch off, defrost,
clean, dry, and leave the door open to prevent mould
developing within the appliance.
W ARNIN G
The refrigerant isobutane (R600a) is contained within the
refrigerant circuit of the appliance, a natural gas with a
high level of environmental compatibility, which is
nevertheless flammable. During transportation and
installation of the appliance, ensure that none of the
components of the refrigerant circuit becomes damaged.
2.5 Accessories and Spare parts
Incorrect components can lead to personal injury or
damage to the appliance. Only use original Linärie spare
parts for repairs.
Modifications, additions or alterations to the appliance
can lead to safety risks. If spare parts or accessories from
other manufacturers are used, the warranty will be
invalidated, and Linärie cannot accept liability.
Please check www.linarie.com.au for more information.
4