Publicité
Les langues disponibles
Les langues disponibles
1. Remove the bolt and washers at the bottom of the tube and the 4 screws on the base.
Insert the tube properly into the center hole of the base by aligning the holes of the 4 screws
and assemble the tube and base by replacing the washers and bolt and tightening the
screws. Figure 1
2. Loosen the thumbwheel at the top of the tube to release its extensible part, adjust to the
desired height and tighten the thumbwheel. Figure 2
3. Assemble the motor on the tube. Figure 2
4. Consider the length of the power cord required, head tilt, activation of the oscillating mode,
relative to the location of the electrical outlet, the cable should never be tense. Figure 3
5. Place the rear grill on the motor (so that the screw on the edge of the grill serving to
secure the assembly of the two grills is at the bottom) and fix it with the 4 bolts of the motor
(remove them before). Figure 4
6. Remove the blade lock screw on the shaft of the motor block and the shaft protection,
place the blade correctly on the shaft and retighten the screw. The screw must be in the
hollow of the shaft. Check that the blade rotates well by turning it manually. Figure 5
7. Place the front grill on the back grill by aligning the hole of the back grill with the one on
the front grill (security screw) and close all clips. Then tighten the screw to secure the
assembly of the 2 grills.
17
Publicité
