Clatronic DO 3204 Mode D'emploi & Garantie page 42

Консервный ключ на батарейках CLATRONIC DO 3204
В интернет-магазине www.clatronic-shop.com.ua
Charging the Battery
The can opener has two charging contacts on the sides.
• If you would like to charge up the device, place it in the charging station.
• The charging contacts (2) are closed.
• Connect the mains adapter to a 230 V/50 Hz socket.
• The charging lamp lights up when contact has been made with the mains adapter.
•
•
•
•
•
• After the device has charged up please disconnect the mains adapter from the socket.
Opening Cans
• Open the cutting lever (see illustration A).
• Place the blade against the lid (see illustration B). The toothed wheel grips under the
edge of the lid.
• Close the cutting lever until the motor starts (see illustration C). The magnet holds the lid
GB
of the can in place.
• Open the cutting lever once the lid has been opened.
• Take the can opener and the lid off the can (see illustration D).
• Always remove the mains plug from the socket before cleaning the device!
• Never immerse the device in water!
• Do not use any sharp items for cleaning!
• Do not use any caustic or abrasive detergents!
Removable Parts
• The cutting lever can be removed by turning it in an anticlockwise direction and then
taking it out of the can.
42
05-DO 3204.indd 42 05-DO 3204.indd 42
WARNING: Use of Standard and Rechargeable Batteries
Only rechargeable batteries may be charged up with the mains adapter.
Do not replace rechargeable batteries with non-rechargeable ones.
There is a danger of explosion if you attempt to charge up non-rechargeable
batteries!
NOTE:
The lamp does not provide any information on the charge status of the battery.
The charging time the fi rst time the battery is charged is 24 hours and 16 hours
for each subsequent charge.
Cleaning
17.09.2007 15:36:04 Uhr 17.09.2007 15:36:04 Uhr