How to reinstall the door
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentations
of the hinge arms into the bottom edges of the hinge slots. The notches in each
hinge arm must be fully inserted into the bottoms of each slot.
Bottom edge of slot
Bottom edge of slot
Hinge arm
Hinge arm
Indentation
Indentation
3. Open the door fully. If the door will not open fully, the indentations are not
inserted correctly in the bottom edges of each slot.
4. Push the hinge locks up against the front frame of the oven cavity into the
locked position.
5. Close the oven door.
NX9000T_NX60T8511SS_AA_DG68-01221A-07_EN+MES+CFR.indb 45
NX9000T_NX60T8511SS_AA_DG68-01221A-07_EN+MES+CFR.indb 45
Hinge lock
Locked position
Locked position
Unlocked position
Unlocked position
How to remove and reinstall the Storage drawer
1. Slide open the drawer until it stops.
2. Locate the roller guide clips on either
side. Using both hands, pull down the left
clip while lifting the right clip, and then
remove the drawer.
3. Clean the drawer in warm, soapy water
using a cloth or soft brush. Then, rinse
and dry it thoroughly.
4. Put the drawer in the roller guides on
either side, and then snap the clips into
place.
English 45
2022-04-14 오후 12:58:42
2022-04-14 오후 12:58:42