Publicité
syncing two bases (optional)
A Sync Cord is included with Twin Long and Split King bases only. Not available on Queen, Full or Full-Long size
bases. The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
STEP 1
Unplug base from power source.
STEP 2
Disconnect the power-down box cable from splitter
cable. Make note where the cable was plugged in.
STEP 3
Connect the male end of the sync cord to each splitter cable. Insert
it into the same port you disconnected the power-down box from
in Step 2.
To USB
charger
To LED Light
14
All manuals and user guides at all-guides.com
Control Box
Bed A
Powerdown box
STEP 4
Connect each power-down box male connection to the sync
cord female connection (Refer to the illustration below).
STEP 5
Plug base back into the power source.
STEP 6
Check to ensure all cords are securely attached. Both remotes
will now operate both bases simultaneously (If the remotes
become unpaired, see page 12).
Sync Cord
Powerdown box
Control Box
Bed B
To USB
charger
To LED Light
Publicité
