Summit Treestands Dual Pro Mode D'emploi page 5

5
ASSEMBLY
PLATFORM
1. Position the Left and Right platform
Braces and the Yoke as shown in figure
1. Note that the teeth on the Yoke
should face down as shown.
2. Line up the bolt holes and secure
using one 1 3/4" bolt and lock nut
side as shown in figure 2.
3. Position the Top Ladder Section as
shown in figure 3. Slide the ladder into
the ends of the Platform Braces.
4. Use two 1 3/4" bolts and lock nuts
to secure the ladder section (figure 4).
Leave these hand tight for now.
5. Position the Front and Rear Platform
sections under the support bars as
shown in figure 5. The expanded metal
on the platforms should face down as
shown.
6. Secure the two Platform sections
using eight 2 1/2" bolts and lock nuts
the locations shown. Leave these bolts
hand tight until they are all started.
7. Wrench tighten all bolts from Step
4 and 6.
1 3/4" BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 7
4
5
REAR
PLATFORM
SECTION
(PN 82066.150)
All manuals and user guides at all-guides.com
per
YOKE
(PN 82066.300)
1 3/4" BOLTS, LOCK NUTS -
WRENCH TIGHTEN
2
at
BOLT
HOLES
LEFT
PLATFORM
BRACE
(PN 82066.200)
TOP LADDER
SECTION
(PN 82066.910)
2 1/2" BOLTS, LOCK NUTS -
WRENCH TIGHTEN STEP 7
6
FRONT
PLATFORM
SECTION
(PN 82066.100)
1
RIGHT
PLATFORM
BRACE
(PN 82066.250)
3
COUPLER
PG 5