Publicité
1.
Touch/slide auto temperature button next to flame button to ON.
If the room temperature is lower than the set temperature, the flame height stays on high for a longer period of time. If the room tem-
perature is higher than the set temperature, the flame height stays on low for a longer period of time.
2.
Choose the time button (15 min, 20 min, or 25 min). The percentage of energy saved is shown in the circle/leaf.
NOTE: A shorter time cycle results in a more active flame picture.
The room temperature is measured and then compared
to the set temperature. The flame height automatically
adjusts to achieve the set temperature.
1. Select Thermostatic Mode from the left sidebar.
2.0Touch the color wheel to set the temperature. Blue is
the low- est temperature setting and red is the highest.
After touching the color wheel, the new set temperature is
shown in the middle of the circle for apprx. 3 seconds.
After 3 seconds, the room temperature is shown in the
middle of the circle. An arrow either above or below the
At the end of a preset countdown time, the fire
turns off.
1. Select Countdown Timer from the left or
right/bottom sidebars.
2. Spin the hour wheel to set hour. Spin the minute
wheel to set minutes.
3. Touch power button to start Countdown Timer.
The time remaining is shown on top of screen next
to hourglass icon.
4. Touch power button to stop Countdown Timer.
Each of 8 programs can be set to go ON and OFF at
specific times at set temperatures.
1. Select Program Mode from the left sidebar.
2. Turn ON desired Program (1 – 8) by touching the
power button.
3. To change days, times, or ON/OFF temperature, touch
the program number (circle 1).
4. Touch the section of the setting wheel to be
changed (time, temp, day). Change the setting.
5. Confirm your changes by touching the yellow
check mark.
Save energy while enjoying a changing, real-
istic flame picture.
1.
2.
and high fire.
3.
93
93
room temperature indicates the flame height
going up or down to reach set temperature.
NOTE: Countdown Timer only works in
Manual, Thermostatic, and Eco modes.
NOTE: To delete a program, touch that
program number and go to program
settings. Touch red CLEAR button and
then touch the red check mark.
Select Eco Mode from the left sidebar.
Choose between low fire, medium fire,
Choose time button (15 min, 20 min,
or 25 min). The percent- age of energy
saved is shown in the circle/leaf.
NOTE: A shorter time cycle re-
sults in a more active flame pic-
ture. Automatic Energy Saving
Mode Corresponds to the set
temperature in Thermostatic
Mode.
Page.83
Publicité
