Publicité
Les langues disponibles
Les langues disponibles
Loading the Battery
Before using the
MyVideo
, you must load Lithium-ion
TM
rechargeable battery
1.
Push battery latch to remove cover.
2.
Insert the battery following to the correct polarity marks
( + or -).
3.
Close the battery cover firmly.
Note
•
When the battery is absent or low, the date and time
will be reset. See page 17 to set date/ time.
Charging your Battery
Fully charge the supplied battery before using the
Extend the USB port: Press the USB latch and the USB arm pops out automatically.
Connect
MyVideo
to the open USB port on your PC or Mac.
TM
Retract the USB port: Press and release the USB latch and push the USB arm backward until it locked.
Press
Two charging modes are
available:
1.Normal Charging Mode: When MyVideo
•
Note: LCD will be turned off after 5 seconds. Press any button [except Record/Enter
button (
)] to turn on the LCD again. (Normal charging time is approximately 12 hours.)
Normal Charging mode
Note
•
Product is not intended for children. Use caution when extending USB port to avoid injury.
EN
All manuals and user guides at all-guides.com
Section 2
Getting Started
1
2
MyVideo
for the first time.
TM
is plugged to a computer, it is in normal charging mode.
TM
Battery charging completed
6
2. Express charging Mode: In normal charging mode, press Record/Enter Button (
express charging mode. Press again to return to Normal Charging Mode (Express charging time is
approximately 4.5 hours to fully charge the battery)
3
Important
•
Note: During Express Charging Mode, camcorder will not able to transfer files to computer.
Safely Remove from Computer (PC)
Note
•
1.
While in Normal Charging Mode, using your mouse,
(
) on the tasktray
2.
From the "Safely Remove Hardware" window (shown lower right), select "USB Mass Storage Device"
and click the "Stop" button. The "Stop a Hardware Device" window will pop up. Click "OK". When the
"Safe to Remove Hardware" window is displayed, you may remove the unit from the USB cable or
remove the USB cable from the computer.
If the "Safely Remove Hardware" icon is not displayed on the tasktray, please double click on
[My Computer]. Right click on [Memorex ] and left click on [Eject]. Then it is safe to remove
the unit from the computer.
To retract the USB: Press and release the USB latch and push the USB arm backward.
Express charging mode
Fully charge your new battery for the first time using the Normal Charge Mode.
To avoid damage to the unit or data loss, always follow the procedure listed below before
disconnecting the unit from the USB port on your computer.
.
Note
7
) to switch to
double-click Safely Remove Hardware icon
EN
Publicité
