Publicité
Intended Use
The pond aerator is designed for light water circulation and thus for
oxygenation of small garden ponds. In summer when high tempera-
tures are present, a kind of "film" can build up on the pond surface
and the surface does not absorb oxygen. The oxygen level de-
creases. Due to the rising air bubbles created by the pond aerator,
the pond surface is constantly in motion and oxygen can be ab-
sorbed at the surface.
Install the pump on the edge of the pond. The pump is powered via
the solar module and operated independently from the mains in
direct sunlight. The pump pumps the air through a 2 meter silicone
tube to the aeration stone. Using the ground stake the solar panel
can be attached on the ground.
Assembling and Operation
1. Connect the plug of the pump cable (1) to
the socket at the rear of the solar module
(2). Adjust the front side of the solar mod-
ule directly towards the position of the sun
at noontime. Setup the solar module by
using the ground stake (5) that can be
extended with the extension piece (4).
Attach the solar module holder (3) to the
top part of the solar module (see picture
on the right). Avoid any form of shading in
order to achieve the highest possible
yield.
2. Put the aeration stones (7) on the one end of the air hoses (6).
3. Connect the other end of the air hoses to the pump (1).
4. Roll out the cable of the pump and install the pump on the edge
of the pond.
5. Put the aeration stone into the pond (approx. 30 cm below the
pond surface). If possible, put the aeration stone on top of some
Operation
7
Publicité
