Perel CWB019 Notice D'emploi page 4

1. Introduction
Thank you for choosing Perel
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
•
Damage caused by user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
•
Check the contents prior to assembly. Use proper tools and never use defective or deformed
parts as an improper installation may cause serious injury.
•
Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware
for mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
•
Respect the product's max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
•
An adequate mounting is essential and falls outside the responsibility of Velleman nv. Respect
all installation and operating directions of the device to be mounted/installed (LCD/plasma
display).
•
Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
•
Keep fingers away from articulations to avoid injury. Keep the device out of reach of children
and unauthorized users at all times.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
•
for LCD/plasma TV
•
easy installation
•
in accordance with VESA standard 50/75/100/200/200X100mm
•
comes with all necessary plugs and screws for assembly and mounting
5. Installation
Refer to the illustrations on pages 2 and 3 of this manual.
1) Use the wall mounting bracket to determine and indicate the position of the mounting holes.
1a) When mounting on a brick or concrete wall, drill holes size Ø8mm and at least 60mm deep at
the indicated positions. Insert the included anchors [E] and mount the wall mounting bracket
on the wall using the 6 included screws [D] (supporting arm at the top!).
1b) When mounting on a wooden wall or wall support, drill holes size Ø3mm and at least 60mm
deep at the indicated positions. Make sure all the holes are blind holes. Mount the wall
mounting bracket on the wall using the 6 included screws [D] (supporting arm at the top!).
2) Mount the yoke on the TV mounting bracket using bolt [J] and nut [H].
3) Mount the TV mounting bracket on the back of the TV as indicated. Depending on the TV
screen, use the correct screws [A], [B] or [C].
4) Hold the screen tight while attaching the TV mounting bracket to the wall mounting bracket.
Use bolt [F] and nut [G] together with the 2 washers [I] as indicated. Position the TV in the
desired horizontal angle and tighten the nut [G].
5) To change the vertical angle of the TV-screen, hold the TV tight and loosen the turning knob
[H] (counter clockwise), move and hold the screen into the desired angle while tighten the
turning knob [H] (clockwise).
09/11/2010
CWB019
User manual
®
!! Please read the manual thoroughly before bringing this device into
4
© Velleman nv