König Electronic HC-SH10 Mode D'emploi page 2

Multi colour LED shower
Please handle the product with care, to prevent damage to the showerhead.
You are strongly recommended to read and follow the manual carefully before use. Please do not use the
product in a corrosive environment; otherwise the product will not work properly for a long time.
Features of LED shower
Material: ABS, Electroplating
Ambient temperature: 0-60 Celsius
Ambient humidity: 10-90%
Minimum water pressure: 0.2PAR
Multi colour with temperature control
- green colour temperatu re lower than 32 degrees Celsius
- blue colour temperature between 33 and 41 degrees Celsius
- red colour temperature between 42 and 45 degrees Celsius
Above 46 degrees Celsius RED colour will flash
LED Quantity: 12 high brightness LED with diameter of 5mm.
After the LED shower is well installed, open the tap, the power generation device inside LED shower will be
driven to make LED light when water pressure reaches 0.2PAR
How to install LED shower
Step 1: Put LED shower onto hose that connects with water pipe;
Step 2: Open the tap completely, then LED shower should work properly.
Note: If LED shower is not working properly, please check if water pressure reaches 0.2PAR;
If LED shower still fails to work, please contact your supplier.
Safety precautions:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
product to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage caused
due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective holders and
are hereby recognized as such.
Keep this manual for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for these
products.
ENGLISH
To reduce risk of electric shock, this product should ONLY be opened by an
authorized technician when service is required. Disconnect the product from
mains and other equipment if a problem should occur. Do not expose the
2