Set Temperature; Using The Device Without Power; Using The Device In A Car (Battery Protection) - MAGIRA Arctic DF36-C Manuel D'utilisation

3.4 Set Temperature

To set the temperature in the cooling zone, press the
respective temperature controls +/-
zone and +/-

3.5 Using the Device Without Power

Please ensure an uninterrupted power supply during operation.
The device is not designed for operation without power
supply and can only keep its temperature to a limited time,
depending on the outside temperature.

3.6 Using the Device in a Car (Battery Protection)

The device is equipped with a three-stage battery protection.
To protect your battery, the device switches off when the
battery voltage falls below the respective battery voltage.
Use the High mode if you have connected the device to
•
your starter battery
• Use the Medium mode if you have connected the device
to your starter battery and the conditions are good (e.g. no
severe cold, no severe heat, no long periods of standing)
• Use the Low mode only when using separate supply batte-
ries to ensure vehicle starting. If this mode is used when
connected to the starter battery, it may not be possible to
start the vehicle
32
14
for the right cooling zone.
The cooling zones can be set diffe-
rently using the respective tempe-
rature controllers.
13
Please note that the left cooling
zone can never be colder than the
14
right cooling zone
Example:
✔ Left: 5 °C
✔ Left: 5 °C
✔ Left: - 15 °C
✖ Left: - 15 °C
13
for the left cooling
Right: − 15 °C
Right: 5 °C
Right: − 15 °C
Right: 5 °C