Isotek EVO3 SYNCRO UNI Instructions D'installation

All manuals and user guides at all-guides.com
EVO3 SYNCRO UNI
INSTALLATION INSTRUCTIONS

SAFETY FIRST
PLEASE READ THE FOLLOWING INSTRUCTIONS
BEFORE INSTALLATION
DO NOT expose this product to dripping or splashing and no
objects filled with liquids, such as vases, shall be placed near the
apparatus. If liquid enters the chassis immediately unplug from
the wall socket.
DO NOT impede ventilation by covering the ventilation openings
with items, such as newspapers, table-cloths, curtains, etc.;
DO NOT expose this product to naked flame sources, such as
lighted candles, these should not be placed near the apparatus;
MAKE SURE that this appliance (CLASS 1) is connected to a mains
outlet socket with protective earth.
PLEASE NOTE that the mains plug is used as the disconnect
device and must remain readily operable.
OUTPUT SOCKETS
ADDITIONAL INFORMATION ON FUSING AND RATINGS
A
The output socket marked 'A' is designed for use with all
electrical devices. For the 10A version of Syncro Uni the socket
is protected by a 10A fuse (T10AH250). This can be located in
the draw tray under the IEC input.
The rated maximum total load for is 10A, 2300W or 16A, 3680W
depending upon mode.
IEC INPUT
1