Luminiz TRF102300 C Guide Rapide

MODEL NO.: TRF102300----C
300 WATT 12V AC LANDSCAPE LIGHTING TRANSFORMER FOR USE ON 120V CIRCUITS ONLY.
OUTDOOR RECEPTACLE SHOULD BE OF "GFCI" TYPE
NOT FOR USE WITH SUBMERSIBLE FIXTURES
• This transformer has an output rating of 300W at 12V AC.
• The load connected to this transformer should not exceed 300W.
e.g. 6 x 50W = 300w, 8 x 35W = 280W, 15 x 20W= 300W.
•
Should a short circuit or overload occur, the secondary breaker will trip and shut off the system.
•
Remove the cause of the shutdown and wait 4 minutes, and then reset the breaker by pressing the
"RESET" button.
•
Be aware of the miximum ampacity of the low voltage cable used in the installation. When in doubt as
to what size cable to use for the installation, contact a qualified electrician.
•
The ambient temperature range in which this transformer will operate is from - 30˚C to 40.5˚C.
•
This transformer should be mounted with its bottom edge at least 40 inches above the ground.
•
The transformer should have normal daylight exposure. Do not mount the transformer in a dark or
heavily obscured location, as the photo cell will turn the system on prematurely. (See Fig.2)
•
Always plug the transformer into a grounded 120V AC receptacle.
OPERATING INSTRUCTIONS
•
Plug the unit in.
•
Upon switching the system ON, the symbol "A" will appear on the display. "A" stands for "AUTOMATIC",
and it means that the system is controlled by the photocell. With this setting, the system will turn ON
at dusk and OFF at dawn, automatically.
Press the "UP" arrow and "1" will appear on the display. This mean that the lights will turn ON at dusk
•
for one hour. There is a total of up to 9 hours interval setting.
•
Pressing the "UP" arrow again while "9" is displayed, a "." will be displayed. This indicates the system
will be turn OFF.
•
Pressing the "UP" button again while "." is displayed, an "0" symbol will be displayed. This setting
overrides the photocell and turns the system ON manually for daytime use and testing.
•
Using the "UP" arrow, the settings are displayed in this sequence:
"A", "1", "2", "3", "4", "5", "6", "7", "8", "9", ".", "0".
•
The sequence is reversed when using the "DOWN" arrow.
CONNECTING THE LOW VOLTAGE CABLE
Strip 1/2" of insulation off the ends of the low voltage cable. Insert stripped ends into terminal block
opening marked "COM" and "12V". Tighten set screws securely onto the bare wire. Make sure insulation
clears terminal block.
1/2"(1.27CM)
2"(5.8CM)
Designed and Imported by Luminiz Inc. / 27 Leading Rd, Etobicoke, ON, M9V 4B7, Canada / 416.494.6616 / 1.855.LUMINIZ / www.luminiz.com
TRANSFORMER•300 WATT LANDSCAPE LIGHTING TRANSFORMER
Position 1 wire under each
terminal pressure plate
and tighten screw securely.
Make sure wire insulation
clears pressure plate.
Tighten screw securely.
RESET SWITCH
Press to reset transformer if light goes
out.
Fig.1
3 1/8"
8.0 cm
Fig.2
YES NO
Keep transformer free from any obstructions. This will prevent the photo cell
from turning the system "ON" prematurely.
Fig.3
PHOTOCELL
LED BLOCK
The photo cell operates with a slight time delay to prevent false reactions
to momentary changes in ambient light conditions, such as car headlights.
ON/OFF
TIME SETTING