Beper BP.630 Manuel D'instructions page 9

USB rechargeable blender Use instructions
RECHARGE:
The plug for the USB cable is located on the base of the motor housing and is protected by a plastic cover, which
must be raised to insert the cable.
If the red light is on while turning on the appliance, it means that the battery is empty.
During charging the red light will flash until the charge is completed, when the charge is complete the light will
turn blue.
USAGE:
Before the first use, clean the product as indicated in the paragraph "cleaning".
Cut the ingredients into pieces of about 2 cm taking care to remove any very hard pits, shells and / or skin if the
ingredients are provided.
Put the ingredients in the container and make sure to add water and / or milk, taking care not to exceed the
maximum level (400 ml) indicated on the container. Failure to add liquid will affect the operation of the product.
Turning the motor housing upside down, screw it over the container.
Press the ON / OFF button and keep it pressed for about 3 seconds, until the blue light flashes, then the ap-
pliance starts to whisk, it is advisable to shake the blender during processing by holding it firmly, the light goes
off when the operation is finished.
Remove the motor body from the container then position the cover.
Note: After 4 consecutive work cycles, the operating light will start to flash, indicating that the product must be
switched off and let rest for at least 5 minutes to prevent the engine from overheating.
Warning: Before first use, make sure the battery is fully charged.
CLEANING:
Fill the container with water, assemble the motor housing over the container and operate the product for about
20 seconds, the blades will be cleaned automatically. Dry carefully.
Take care that the blade is sharp.
The motor housing can be cleaned with a soft, slightly damp cloth.
TROUBLE SHOOTING :
Problem
The appliance doesn't work
The ingredients can't be blended
The light flashes but the product
doesn't work
All manuals and user guides at all-guides.com
Possibile causes
The product have been used for
too long time
The blade is blocked
The container is not well assem-
bled.
The battery is low power
The container is too much or too
low loaded
The ingredients are too big or too
hard ;
Liquid has not been added
Wrong assemble of the container
Low power battery
Container have been overloaded
What to do
Let the appliance rest for about
10 minutes than try again.
Remove the ingredients that block
the blades.
Try to assemble again.
Recharge the appliance .
Pay attention to the min (100ml)
and max (400ml) levels shown on
the container.
Cut the ingredients in smaller
pieces.
Add water or other liquid.
Reassemble the container.
Recharge the battery.
Remove exceeding ingredients .
9
EN