Miles Industries Valor GV60NTK Directives D'installation page 2

Remote Control Operation
Radio Frequency
315 MHz for USA and Canada.
This device complies with Part 15 of the FCC Rules
and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: Before using the remote control system for
the fi rst time, the receiver and the handset must be
synchronized. See the section Remote Control Initial Set-
up on the previous page of this manual.
IMPORTANT: BEFORE YOU BEGIN, please note that
on this system, the settings of time, temperature and
automatic ON/OFF can only be programmed when
the function display is fl ashing. Be patient when
programming as it can take a few seconds to set.
Note: In the TEMP or TIMER modes, the remote handset
senses the room temperature and adjusts the fl ame
accordingly.
To communicate, the handset should be within 15 feet
(4.5 meters) of the fi replace.
Do not leave the handset on the mantel or hearth.
TO TURN ON APPLIANCE
CAUTION
When pilot ignition is confi rmed, motor turns
automatically to maximum fl ame height.
On the valve, turn MAN knob on the ON, full
counterclockwise
Place ON/OFF switch (if equipped) in I (ON position).
Simultaneously press the OFF and
(large fl ame) buttons until a short
beep confi rms the start sequence has
begun; release buttons.
2
All manuals and user guides at all-guides.com
position.
Current
temperature Handset
(F or C) sensor
OFF
(turns the burner
and the pilot off )
TO TURN OFF APPLIANCE
Press the (small fl ame) button to
reduce the fl ame to pilot.
Press the OFF button to turn the pilot
off .
Battery status
Current time
(12 or 24 hour clock)
Large flame
button (flames
up, sets hours,
temperature)
Small flame
button (flames
down and off,
sets minutes)